The 360° panoramic FE (fisheye) camera can be installed on, at your choice, the ceiling, the wall, or the desktop. Here is the installation guide for you.

Applies to: FE-W, FE-P.

Part 1. Mount the camera to the wall

Step 1. Before drilling the required holes, mark the direction of the lock printed on the mounting base. Make sure the lock is facing up, as shown in the diagram. This will guide you to put the mount base in the same orientation when installing.
Step 2. Drill holes with the mounting hole template. Use the drywall anchors included in the package if needed. And secure the mount base to the wall with screws and keep its cable groove facing downward.
Step 3. Run the cable of the fisheye camera through the cable groove on the mount base.

install_fisheye_camera_1.png

Step 4. Attach the camera to the base and rotate the camera counterclockwise to lock it in position. Make sure the orientation arrow on the camera and the lock on the base are aligned.

install_fisheye_camera_2.png

Step 5. If you want to remove the camera from the mount base, press the release mechanism and rotate the camera clockwise.

install_fisheye_camera_3.png

Part 2. Mount the camera on the ceiling

Step 1. Drill holes with the mounting hole template. Use the drywall anchors in the package if needed.
Step 2. Secure the mount base to the ceiling with screws.
Step 3. Run the cable of the fisheye camera through the cable groove on the mount base, and rotate the camera counterclockwise to lock it in position.

install_fisheye_camera_4.png

Note: Fit the three mounting holes of the camera into the mount base.